www.TK560.com

Thanks Crashmann!

I'm using ceramic infra red E-mitters from Tempco
http://www.tempco.com/Infrared/Ceramic%20Emitter%20Style%20CRH.html

And this heat controller from RK instruments. I used 2 of ...

Here it is! It only took me a year and a half. I am a full time dad so chasing a toddler around takes most of my time and attention Smile

Specs:

2 feet x 2 feet frame
25 ceramic elements
2 zone ...

I know this is an older post but finished my table. Works good!

I ended up using the coupler with rubber O ring described above to lock the platen down.

I used 1/4" wood strips arranged nea ...

I think I figured it out. The hinge point on one side is about 1/16" closer to the vertical frame than the other side. Its throwing the tension off.

I tried sanding down the sliders but I'll ...

Hi all, looking for some help / advice.

I'm almost done my frame for my protoform style table. I did change the measurements slightly to suit my application, but I built a mockup to make sure all t ...

Thanks Charlie.

You're totally right about the scooter parts. I figure vac forming will be cheaper than fiberglass in the long run, and I can use the table for other things too.

Thanks for the tips and feedback so far!

Hi all, I bought the Protoform plans a few years back, and I'm building a small table for personal use.

I had a couple questions I was hoping to get some feedback on:

I can't seem to find in the ...

Hi all, new to this forum but been around a while in prop and costume circles.

I built a table way back (over + wood frame + foam seal + shop vac) but now building something more consistent. Prima ...