www.TK560.com

I havent cast my mold yet, I just now got it ordered. My first order of PETG was made by makolon, but after some research I think vivak is a better choice, they say this is available in transparent co ...

Yea I used small river rocks, thanks for all the great info. I should be getting in my new switch any day now, I'm ready to get that petg another try, that's what everybody is asking for.does anybody ...

I finally got to order my bc8009, it will hold only 5 gallons. I had to make a bigger piece to go into my mold as a backfill, the first one didn't take up enough room, it was going to hold 7 gallon. I ...

Well, I got ahold of Scott and he gave me some every good information. I'm very thankful for all this great advise, there is know way I could have accomplished this project with out the great leaders ...

I did form a piece of acrylic with perfect results, but when I tried to pull the form off it cracked along the bottom. The center section of my oven is wide open right now, last week one of my switche ...

Do you have to preheat PETG, I tried a piece with hundred of small bubbles.

Man I tried a sheet of petg, and man what a big difference form hips. I can heat hips for about 2 min, I let that petg sit in there for about 7 min and still not real soft in the corners.

It's very close, just didn't form properly on the front grill area. This is the piece that sucked the hole and lost some of it's shape. I sent this photo to some dealers and they are very interested, ...

Yes the mdf board is on my list for tomorrow. I'm going to fill the undercut with the board and a base with a bevel.
http://i1122.photobucket.com/albums/l531/MDR38/1328657826.jpg?t=1328657828
This i ...

Ok, the electrician didn't fix the controller correct, it's on or off, I guess I'll order another one. I fired the machine up again, to try one more piece, I added a small piece under the mold to try ...

Ok, I had my electrician come over, we ran a few test and found that the center bakatronic switch was bad, he does work on switch boards, so he soldered the switch back together. I did have just the t ...

http://emob1122.photobucket.com/albums/l531/MDR38/1328630378.jpg?t=1328630379
Ok hear is the pic of the hole at the base of the platen right under the mold. If I had a problem with the connection to ...

Ok, I raised the platen up 1" and everything was looking real good until POP!

http://i1122.photobucket.com/albums/l531/MDR38/1328630378.jpg

I was using the plastic that didn't form the firs ...

Ok, Thanks for the suggestions The size is 2x4 .60 hips. The first attempt I didn't let the plastic sag much at all, and didn't get the carri ...

I finally tried the machine out and it went real good until I got to the forming part.
http://i1122.photobucket.com/albums/l531/MDR38/1328583476.jpg

I tried three times with the same result. I fir ...