www.TK560.com

Opened up the walls and installed the electrical wires and outlets and tied it into the panel box. Put it all back together and reinstalled the wall with 4 new outlets - oven, vac pump and two control ...

Hi Dale.

Thank you for the comments!

I will be buying custom sized plastic to fit within the plastic holding frame which should be something along 27x27 inches.

At least that is what the busi ...

Bumping this thread as I am actually getting back to building the table.

Wow, it's been over 6 years since I started and I feel like I am only halfway there. Crying or Very sad

I will have to have the sta ...

Looks like my table frame the day before yesterday. It acted as a catch all. Now it is moved to a new location and will start building it to finish - again. Good luck. Keep motivated!

Reviving my old thread.

I finally dusted off my vac table parts and moved them to another shed which has more open space and better insulated.

I re-read the posts and realized that I may be bett ...

Anything with an electric coil for heat - for example a heat gun, hair dryer, electric furnace, electric water heater - a motor - for example a refrigerator, a vacuum pump, vacuum cleaner, exhaust fan ...

A shocking story for your enjoyment...

Back around 1992 I was an electrician's apprentice in California. My supervisor was taking a small cover off of a fantastically huge (we're talking 40 to 50 f ...

At 240 Volts it would pull 10 amps.

Not sure how your power company rates pricing but where I live it would cut the cost in half as power here is read off of the highest leg.

Well, I am dusting off the spare parts and getting back to putting this machine together.

I will be ordering the niachrome wiring and standoffs tomorrow for starters and am looking at strip heaters ...

You'd be surprised at how fast metal will oxidize. The original lower half of the platen chamber was carbon steel and it rusted a lot of its surface in the 2 years it sat in my shed. I had a new o ...

The differences off hand are that the aluminum is lighter in weight and is anodized to prevent oxidation.

huh . are planning on moving it around a lot for the next couple centuries ? Wink

that ...

that 80/20 looks like a lot of fun to work with - very aesthetically satisfying. How does it compare in price to slotted steel found in most hardware stores ? (which is almost as modular and adjustabl ...

This is what I used http://www.globalindustrial.com/images/picgroup/30018704.jpg

This get you all of the oven sides, frame, and and cart all for $200. With no fabrication. For the oven top I use a ...

The first thing on your to do list should be to drain your pump. The oil is really dirty or it's the wrong oil. Both conditions are bad news for the pump. Unless the E2-M28 takes a special pump oil, y ...

Since my stainless steel oven box with mounts is already made and the plastic holding frames are here, I am going to use strip heaters on the top frame to ensure that it is heated up to prevent the co ...