www.TK560.com

I am in the process of making my helmet and I am trying to figure out how to get past the undercutting of the chin area.

Yeah, you're right on that......
Does it make sense that the Dome Side Profile would be almost 10" front to back? I thought that was big but maybe not. If 10" works, then it might be an eng ...

In that same selection with the diagrams on grid paper there's a ruler in a pict titled Hand - 03.

Yes I thought about it being metric as well so. I thought 1 small box might = 1CM so that would ...

I was reviewing the blaxmyth molds and design techniques and had a quick question. On page 2 it gives a very good diagram on the grid paper but I just wanted to know if anyone knew for sure what scale ...

just for curiosity, why go through the fuss of building your own tank? it seems like the raw materials would cost almost as much as buying one, never mind the labor...

I am sure that normally the ...

I am leaning toward a tank that will be about 30 gallons. I have access to steel to about 1 inch thick. I will run the numbers but I am sure that it will be fine.

I like your design. Very nice and compact and looks like it will work well with your application. I was curious though when the frame is up near the oven what keeps it up. I did not see any locking m ...

the magic number seems to be 25 inches, less than that and sometimes you will lack detail, of course, thats for PETG and ABS. Other plastics are much more forgiving and need far less vacuum

Wow so ...

I know I saw this somewhere but I can not find the post again. What PSI are you pulling your storage tank down to for the vacuum?

Thanks stormtrooperguy I had no idea I needed it to be that thick. I am still making my former and I was simply going by the guide on this sight for the thickness I would need.

"For trooper ...

I know that for most armor I am going to need .060 and .080 but I was curious if anyone had any experience with the .040. I was thinking about ordering some of it to use for my test pulls and to waste ...

Thanks. Thats pretty much what I was thinking so I will go with a small area. I am going with a shop vac for now with plans to upgrade at a later date.

I am at the point where I am going to be putting the entire thing together but was curious if the amount of air space in the box that the platen sets on makes a difference. I am going to be having my ...

I have been looking for a hobby that is in a reasonable price range. That is also not time specific and can be done at a person own place. I also love how it appears that there is no "right" ...