| View previous topic :: View next topic |
| Author |
Message |
kruzer
Newbie
Joined: 30 Apr 2010
Posts: 14
Location: newport, oregon
|
 Posted: Sat May 01, 2010 11:43 pm Post subject: yet, another from OreGun here |
 |
|
Yo everyone!
Another one from Oregon here.
While am writing this note.... I need a vacuum formed part in a hurry and am still trying to figure out what machine am going to build.
If anyone would be kind enough to run two parts off of my wood mold, it would be greatly appreciated. It's for a camcorder ... used as a 'matt box' in front of the lens. A small piece about 9X6X4" high.
My apology for not starting a new thread for this...am pressed for time. |
|
| Back to top |
|
 |
CJanssen
Expert
Joined: 17 Feb 2007
Posts: 215
Location: Beaverton OR
|
| Posted: Tue May 04, 2010 7:30 pm Post subject: |
|
|
Cool, another Oregonian.....welcome to the board.
CJ
_________________
"What, you think your some kind of Jedi?" |
|
| Back to top |
|
|
spektr
Master
Joined: 07 Jan 2008
Posts: 425
|
| Posted: Wed May 05, 2010 12:49 pm Post subject: |
|
|
im up in mount vernon, how many you need, out of what plastic?
Scott |
|
| Back to top |
|
|
kruzer
Newbie
Joined: 30 Apr 2010
Posts: 14
Location: newport, oregon
|
| Posted: Wed May 05, 2010 4:41 pm Post subject: Got it |
|
|
Hi
I think I have a place now in Oregon to pull off a few samples, until my machine is built.
Thank you very kindly for the offer 
cheers |
|
| Back to top |
|
|
jegner
Site Admin
Joined: 30 May 2003
Posts: 2144
Location: Texas, USA
|
| Posted: Sat May 08, 2010 6:46 am Post subject: |
|
|
| Welcome to the board! |
|
| Back to top |
|
|
|
Log in to check your private messages
Log in
Register
