View previous topic :: View next topic |
Author |
Message |
captmike Novice
Joined: 01 May 2012 Posts: 27 Location: Elberton, Georgia
|
Posted: Fri May 04, 2012 5:59 am Post subject: Hello from Georgia |
|
|
Hello to everyone here and thanks to all who make this great resource available. I am a retired guy who is interested in just about everything. My latest interest has been casting pieces from concrete and plaster using plastic and latex molds. As usual, I immediately wanted to make improvements to the plastic molds I was using and that led to researching about how to vacuum form plastic. My needs right now are rather small and basic and I will start a thread asking questions soon. Thanks in advance for help and advise.
Mike |
|
Back to top |
|
![](templates/aluminoid/images/spacer.gif) |
IMMark Expert
Joined: 18 Nov 2010 Posts: 189 Location: Columbus, Ohio
|
Posted: Fri May 04, 2012 8:00 am Post subject: |
|
|
Hi Mike
Always good to see a new face!
Best of luck on your projects, hope that we can help.
Mark |
|
Back to top |
|
![](templates/aluminoid/images/spacer.gif) |
jegner Site Admin
![](http://www.tk560.com/TK560avitar.gif)
Joined: 30 May 2003 Posts: 2144 Location: Texas, USA
|
Posted: Thu May 10, 2012 12:40 pm Post subject: |
|
|
Welcome to the board! |
|
Back to top |
|
![](templates/aluminoid/images/spacer.gif) |
jdougn Guru
Joined: 18 Mar 2009 Posts: 714 Location: Louisville KY area
|
Posted: Wed May 30, 2012 7:21 am Post subject: |
|
|
Hey Mike, welcome to the forum. I saw the thread where you'd posted pics of the your former & some molds. Looks like you're off to a good start. _________________ DougN - Just in case you're wondering, I got my "rating" legitimately... by posting aimless drivel, useless advice, and pointless questions. |
|
Back to top |
|
![](templates/aluminoid/images/spacer.gif) |
|