| View previous topic :: View next topic |
| Author |
Message |
Jeprachaun
Newbie
Joined: 12 Apr 2008
Posts: 8
Location: Southern California
|
 Posted: Sat Apr 19, 2008 1:32 pm Post subject: Hello from Southern California! |
 |
|
Hello everyone! I found Jim's site through youtube and his instructional videos and have since done quite a bit of research on vacuum forming. I am currently in the process of building my table and collecting supplies. This is a great site with a lot of information available. I look forward to posting in the near future and hopefully contributing to the community where it is possible. Thank you/
O'Malley |
|
| Back to top |
|
 |
LaughingCheese
Expert
Joined: 24 Mar 2008
Posts: 138
|
| Posted: Sun Apr 20, 2008 5:21 pm Post subject: Re: Hello from Southern California! |
|
|
| Jeprachaun wrote: | Hello everyone! I found Jim's site through youtube and his instructional videos and have since done quite a bit of research on vacuum forming. I am currently in the process of building my table and collecting supplies. This is a great site with a lot of information available. I look forward to posting in the near future and hopefully contributing to the community where it is possible. Thank you/
O'Malley |
Hey I'm in SoCal too! Sweet!
I'm hoping to build my table soon.
Good luck with yours! |
|
| Back to top |
|
|
Jeprachaun
Newbie
Joined: 12 Apr 2008
Posts: 8
Location: Southern California
|
| Posted: Sun Apr 20, 2008 6:39 pm Post subject: |
|
|
Great to hear that there are some other builders near me. What part of Socal, if you don't mind me asking?
O'Malley |
|
| Back to top |
|
|
Jeprachaun
Newbie
Joined: 12 Apr 2008
Posts: 8
Location: Southern California
|
| Posted: Sun Apr 27, 2008 8:35 pm Post subject: |
|
|
Hey guys. I am currently putting the vacuum forming project on the back burner so that I can spend time building a CNC machine (finishing up the research now and should start building soon). I have everything laid out and might start this thing Tuesday if all goes well. I decided to do this first so that I can design the molds on the computer and work from there. I will keep you guys posted once I get started on this thing.
O'Malley |
|
| Back to top |
|
|
TK 109
Guru
Joined: 11 May 2007
Posts: 712
Location: Galena, Ohio
|
| Posted: Mon Apr 28, 2008 7:00 pm Post subject: |
|
|
very nice!
welcome to the boards! an industrial one, aren't you? 
_________________
-Alex
-------------------------------------------------------
 |
|
| Back to top |
|
|
|
Log in to check your private messages
Log in
Register
