|
www.TK560.com Vacuum Forming, Movie Prop, Sci-fi and GIjOE Forum
|
|
|
View previous topic :: View next topic |
Author |
Message |
jegner Site Admin
Joined: 30 May 2003 Posts: 2144 Location: Texas, USA
|
Posted: Wed Jun 25, 2008 7:51 am Post subject: JUNE: Tip of the Month |
|
|
I know it's been a few months since I've added a tip, but I thought I'd try to reanimate this thread. Usually, the tips deal with vacuum forming, or mold making/ props. This month, I'd like to talk about trimming your vac formed plastic. By in large the most common technique to trim your parts out is to use a stout , sharp utility knife, scoring the cut line, and bending and snapping to parts loose. This works great, but sometimes you can crack or break a part if you are not careful.
Another technique is to use a dremel with a cut-off wheel, and use it as a saw. This works pretty well, and can be handy when you need a special trim or cut. Also, a sanding drum on the dremel really helps clean up the edges.
Still another option is to use a 'hot knife' to cut the plastic. These are basically wood-burning tools, or hand-held soldering irons, with a special tip. You have to be careful not to burn stuff with it, but this can be a great option for certain plastics that don't like the score-n-snap technique.
If you have a bandsaw, these work great too. Just be careful, as the plastic tends to stick to the blade after a while, and eventually you will kill the tires on your saw. These can be a pain to find the right parts and replace.
A final option is the die stamp. If your plastic is thin, and your parts small, you can buy or make a die stamp, and hammer out the parts. Commercial printers use this technique all the time, and I suspect that commercial vac-formers have something similar, but think of it as a cookie-cutter on steroids, and you get the idea. Small die stamps can be made from scrap metal, but an edge will need to be applied, and you will want to heat treat it so it keeps it's edge longer. |
|
Back to top |
|
|
TK 109 Guru
Joined: 11 May 2007 Posts: 712 Location: Galena, Ohio
|
Posted: Wed Jun 25, 2008 1:25 pm Post subject: |
|
|
tin snips, utility knife, and a jigsaw work well for me. and a dremel tool comes in handy as well. _________________ -Alex
-------------------------------------------------------
|
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|