|
www.TK560.com Vacuum Forming, Movie Prop, Sci-fi and GIjOE Forum
|
|
|
View previous topic :: View next topic |
Author |
Message |
jegner Site Admin
Joined: 30 May 2003 Posts: 2144 Location: Texas, USA
|
Posted: Tue May 16, 2006 4:49 pm Post subject: Tip of the Week 15-MAY-06 |
|
|
Last week was a wash, so here is this weeks tip[s]:
Use a heat gun to reshape those parts that don't fit so well. Use the low setting, and you can get your trooper helmet ears, or armor knees or collar strips to fit better. Don't dilly-dally around too long, though! Even on the lo setting, a heat gun will blow through HIPS in only a few seconds. Keep the gun a good 6-8 inches away from the surface.
Also,
You can use wood putty to fill cracks in Ultra-Cal, Bondo, cement, etc. Just don't smear too much on at a time, and be sure to remove all the sanding dust before you apply it.
|
|
Back to top |
|
|
ROYAL RED Newbie
Joined: 18 May 2006 Posts: 21
|
Posted: Mon May 22, 2006 11:30 am Post subject: Re: Tip of the Week 15-MAY-06 |
|
|
[quote="jegner"]Don't dilly-dally around too long, though! Even on the lo setting, a heat gun will blow through HIPS in only a few seconds. Keep the gun a good 6-8 inches away from the surface.[/quote]
Jim,
This is a great feature to your forums. Not to mention ... this is a VERY HELPFUL tip. |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|