www.TK560.com Forum Index www.TK560.com
Vacuum Forming, Movie Prop, Sci-fi and GIjOE Forum
 
Log in to check your private messagesLog in to check your private messages

Log inLog in  RegisterRegister


Profile  Search  Memberlist  FAQ  Usergroups
wire lay out?????post distance

 
Post new topic   Reply to topic    www.TK560.com Forum Index -> Vacuum Forming & General Stuff
View previous topic :: View next topic  
Author Message
harley guy
Novice


Joined: 25 Nov 2005
Posts: 71

PostPosted: Sun Dec 04, 2005 8:20 am    Post subject: wire lay out?????post distance Reply with quote

wire lay out?????post distance.what is the measurement between the wire on a 24x24 oven.it looks like the out side ring is 3/4 apart and inside is 1 inch.and does anyone know how far apart u put the posts(terminals).thanks
Back to top
View user's profile Send private message
jegner
Site Admin


Joined: 30 May 2003
Posts: 2144
Location: Texas, USA

PostPosted: Sun Dec 04, 2005 7:54 pm    Post subject: Reply with quote

Here is a wiring diagram from the book.

Just draw a square around it, measure that as 28x28 inches, and scale it from there. IIRC, the outside is about 3/4" from the edge, and then 1.5 r 2" gaps. I had to draw these lines a few times to get it right.
Back to top
View user's profile Send private message Send e-mail Visit poster's website AIM Address
Display posts from previous:   
Post new topic   Reply to topic    www.TK560.com Forum Index -> Vacuum Forming & General Stuff All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

phpBB "skin" by DewChugr


Powered by phpBB © 2001, 2005 phpBB Group