|
www.TK560.com Vacuum Forming, Movie Prop, Sci-fi and GIjOE Forum
|
|
|
View previous topic :: View next topic |
Author |
Message |
Stomper Master
Joined: 01 Oct 2005 Posts: 473 Location: Woodburn, Oregon USA
|
Posted: Sun Dec 18, 2005 2:46 pm Post subject: Easy to use tables to figure electrical loads for heaters! |
|
|
Hey everyone! I see there are a LOT of questions on how to figure the heat output and volts & amperage requirements for setting up the heater sections of your vacuum table projects. Just follow the easy to use examples on the OHMS Law wheel in the supplied picture. All you will need is a meter to make readings.
Also there is 3.41 BTU's per watt.
Hope this helps all you fledgling electrical engineers!
Remember... BE SAFE... just a small jolt can stop your heart in less than... well a heartbeat!
|
|
Back to top |
|
|
jegner Site Admin
Joined: 30 May 2003 Posts: 2144 Location: Texas, USA
|
Posted: Sun Dec 18, 2005 3:20 pm Post subject: |
|
|
Great information! Thanks for sharing!
Good tips! |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|