|
www.TK560.com Vacuum Forming, Movie Prop, Sci-fi and GIjOE Forum
|
|
|
View previous topic :: View next topic |
Author |
Message |
knightshade Expert
Joined: 19 Jun 2005 Posts: 123 Location: Rochester NY
|
Posted: Sat Sep 15, 2007 4:25 pm Post subject: Knightshade's Introduction |
|
|
Hello -
My name is Darren Blum, and I go by KnightShade on a number of forums, including these.
I'm an active member of the 501st Legion. Started as a Darth Maul, and found my way to these forums when I decided to try to make my own TK suit. That was about two years ago, and I have been playing with my vac machine on and off for a while as "free time" allows.
About a year ago I invested in a Gast pump and started to play with pulling ABS.
Now all I need to do is finish my set of molds |
|
Back to top |
|
|
knightshade Expert
Joined: 19 Jun 2005 Posts: 123 Location: Rochester NY
|
Posted: Wed Nov 18, 2015 8:54 pm Post subject: Re: Knightshade's Introduction |
|
|
It has been a long time since I've ventured over here.
Over the past couple of years, my table has fallen into a state of disrepair - so it is time to rebuilt.
In the meanwhile, I've built a 12'x16' 2 story shed in my back yard - so my intent is to get power run to the shed (100 amp subpanel) and get a new vac table running there.
Thought that I should post an updated intro - as I've not had a post here in a few years. It is good to see some familiar faces still around! |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|