www.TK560.com Forum Index www.TK560.com
Vacuum Forming, Movie Prop, Sci-fi and GIjOE Forum
 
Log in to check your private messagesLog in to check your private messages

Log inLog in  RegisterRegister


Profile  Search  Memberlist  FAQ  Usergroups
I finally got it to work!

 
Post new topic   Reply to topic    www.TK560.com Forum Index -> Vacuum Forming & General Stuff
View previous topic :: View next topic  
Author Message
ShadowBlade



Joined: 30 Sep 2005
Posts: 1

PostPosted: Sat Oct 01, 2005 11:08 am    Post subject: I finally got it to work! Reply with quote

I just wanted to say thank you Jegner; because of your site I finally got my vac machine to work. It took me around four months working on/off but I got the oven working etc.

Currently I'm trying to get a 30 amp breaker to power it fully and I'm working on the molds I'm going to pull. For the heating elements though, I didnt use specially ordered NIchrome wire, I used the heating coils off of a heater that was mounted in my wall. It works fine, but the energy draw is just barely too much for my 20 amp breaker so I gotta get a better one. Razz

Once again thank you for your awesome site. I really couldn't have done it withought you. Very Happy
Back to top
View user's profile Send private message
jegner
Site Admin


Joined: 30 May 2003
Posts: 2144
Location: Texas, USA

PostPosted: Tue Oct 11, 2005 12:33 pm    Post subject: Reply with quote

I'm glad you found my information helpful.

Jim
Back to top
View user's profile Send private message Send e-mail Visit poster's website AIM Address
Display posts from previous:   
Post new topic   Reply to topic    www.TK560.com Forum Index -> Vacuum Forming & General Stuff All times are GMT - 6 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

phpBB "skin" by DewChugr


Powered by phpBB © 2001, 2005 phpBB Group